Cloudcrete, Fabrication

This is a record, for now, of our step by step process to make these latex kites!

1: Template printed from from Rhino 3-d model.

2: Template used to cut latex form

3: Edges cleaned with solvent

4.1: Edges adhered with either Liquid Latex

4.2: Or Edges adhered with Rubber Cement

5: Once edges have dried seal with duct tape ( temporary solution until we get the sealed joint that we can trust)

first edge

all edges

gate to fill with concrete

All of the Materials Needed and the three new prototypes

Checking for Holes!

No holes here!